Gentec-EO PC-MAESTRO (Old Software for MAESTRO) - Manual (Page 9)

PC- MAESTRO User’s Manual Revision 1.0 8
2 QUICK START PROCEDURE
1. Open the MAESTRO monitor and follow the instructions to make a measurement.
2. Install the PC-MAESTRO software on a PC.
3. Connect the MAESTRO monitor to the PC with the appropriate USB cable.
a. Verify that the MAESTRO is not in SOLO2 Serial Compatibility or Binary Mode
Measurement and that it is configured to use the USB port. (In the MAESTRO monitor,
go to “Home” menu  “Set Device”  “Serial Commands”)
4. Start the PC-MAESTRO software.
5. Press the Connection button on the top left corner of the main window.
6. Choose the appropriate graphic for your measurement:
a. Real time with bar graph display
b. Scope display
c. Needle display
d. Averaging display
e. Histogram display
f. Statistics display
7. Change the measurement and display options in the appropriate tabs.