Gentec-EO PC-MAESTRO (Old Software for MAESTRO) - Manual (Page 30)

PC- MAESTRO User’s Manual Revision 1.0 29
Fig. 5-18 Statistics display options panel in Energy mode
5.6.2.1 Continuous and Fixed statistics duration mode
In both statistics modes, the statistics start and reset with the
“Start Statistics” button in the controls
section of ribbon bar, or with the button at the top right corner in the statistics graph panel.
The difference between the Fixed and the Continuous modes is that, in the Fixed mode, the statistics will
stop automatically after the duration period. With the Continuous mode, the statistics, after the duration
period has ended, will automatically reset and start again with the same duration period. This will continue
until the stop button is pressed.
Tips
If “Save statistics to the acquisition file” is checked, the Continuous mode
cannot be used. The statistics are entered into a file at the end of the
duration period, so we must use the Fixed duration.
The file used for the statistics is the same as the file used for the
acquisition. Therefore, if the filename of the statistics is changed, the
acquisition log filename will be changed automatically.
To store only the statistics in a file, check the “Save statistics to the
acquisition file ” and start the statistics. To add statistics at the end of an
acquisition log file, check the “Save statistics to the acquisition file” option
and start the acquisition. The statistics will automatically start at the same
time and will be entered in the file at the end of the acquisition.