SecurityMan iCamDVR (after Dec. 2011 shipment) - Manual (Page 34)

34 | SecurityMan
in a form of a map as shown below. This virtual building
region below may apply to other resemblance regional
areas; other geographic area picture may apply.
Click hold and drag CAM1, CAM2, CAM3 and CAM4 icons
of cameras located at the left column to the corresponding
position on the map. Right click on any part of the build-
ing to select “Save Map” to save map setting. To change
icon of the CAM1~4 right click on the CAM1~4 icon and
select “Change icon” or select “Delete” to remove the
camera from Emap, as illustrated in figure 45 below.
Finally, click on button to exit out of Emap Edit and
back to the Emap tab.
To view the emap
Click on the icon button from the main SuperDVR
software interface to enter and view Emap geographic
area and cameras. Cameras cannot be moved or re-
arranged in Emap viewing panel as illustrated in figure 47
below.
The grayed-out MAP2~8 can be enabled and come anoth-
er MAP zone or new MAP area. To enable new MAP zone
right click on any grayed-out MAP2~8 and then select
“Open”, select “Close” to close the opened MAPs, or select
“Rename” to rename the MAPs zone, as illustrated below
in figure 46.
figure 45 - emap CaM1~4 Installation
figure 46 - opening MaPs