IDEC MicroSmart AS-i - Manual (Page 17)

3: I NSTALLATION AND W IRING
3-4 M ICRO S MART AS-I NTERFACE M ASTER M ODULE U SER ’ S M ANUAL
Removing the Direct Mounting Strip
1. Insert a flat screwdriver under the latch of the direct
mounting strip to release the latch (A).
2. Pull out the direct mounting strip (B).
Mounting Hole Layout for Direct Mounting on Panel Surface
Make mounting holes of ø4.3 mm as shown below and use M4 screws (6 or 8 mm long) to mount the AS-Interface master
module on the panel surface.
(A)
(B)
Caution
• Reusing the Direct Mounting Strip
When you attempt to reuse a direct mounting strip, the hook may not catch on the recess suffi-
ciently and may come out easily. When using a direct mounting strip again, be certain to push the
hook deeply into the recess.
103.0 90.0
2-ø4.3
6.3
23.5
3.0
113.0
±
0.2
Direct Mounting Strip
FC4A-PSP1P