LevelOne FGP-2472 - Manual (Page 265)

259
Power Requirement : AC Line
Voltage : 100
∼
240 V
Frequency : 50
∼
60 Hz
Consumption : 380W for FGP-2472
Ambient Temperature : 0
°
to 40
°
C
Humidity : 5% to 90%
Dimensions : 44(H) x 442 (W) x 366 (D) mm for FGP-2472
Comply with FCC Part 15 Class A & CE Mark Approval
Management Software Specifications
System Configuration Auto-negotiation support on 10/100Base-TX ports,
Web browser or console interface can set transmission
speed (10/100Mbps) and operation mode (Full/Half
duplex) on each port, enable/disable any port, set
VLAN group, set Trunk Connection.
Management Agent SNMP support; MIB II, Bridge MIB, RMON MIB
Networking Convergence
Algorithm IEEE 802.1D Spanning Tree
IEEE 802.1w Rapid Spanning Tree
IEEE 802.1s Multiple Spanning Tree
VLAN Function
Port-Base / 802.1Q-Tagged, allowed up to 256 active
VLANs in one switch.
Trunk Function Ports trunk connections allowed
Bandwidth Control Supports by-port Egress/Ingress rate control
Quality of Service (QoS) Referred as Class of Service (CoS) by the
IEEE 802.1P standard
Four queues per port Packet transmission schedule
using Weighted Round Robin (WRR) User-defined
weight Classification of packet priority can be based on
either a VLAN tag on packet or a user-defined
port priority.
Security
Limit number of MAC addresses learned per
port static MAC addresses stay in the filtering table.
IEEE802.1X Port Authentication
Multicast
IP Multicast Filtering by passively snooping
on the IGMP Query.
IP Multicast : IGMP Snooping
Maximum of 256 active entries of Group
Network Management
One RS-232 port as local control console
Telnet remote control console
SNMP agent : MIB-2 (RFC 1213)
Bridge MIB (RFC 1493)
RMON MIB (RFC 1757)-statistics
Ethernet-like MIB (RFC 1643)
Web browser support based on HTTP Server
and CGI parser TFTP software-upgrade capability.
Power over Ethernet IEEE 802.3af compliant
Endpoint with 48VDC power through RJ-45 pin 1,2,3,6
Auto detect powered device and consumption levels
Supports per port power consumption monitoring
Smart feature for PD on/off, PD detection, power level,
PD status and power feeding priority
Supports per port power priority setting.
Note: Any specification is subject to change without notice.