LevelOne IES-1081 User Manual
Page 100
IES-1081 User Manual
Page 100
GROUP <1-1> The ID of the bridge group to which this hello time is assigned.
HELLOTIME <1-9> The hello BPDU interval in seconds.
4. Example:
The following example sets the hello-time HELLOTIME (9) of bridge GROUP (1):
switch_a(config)#bridge 1 hello-time 9
switch_a(config)#
Max Age (sec) (6..28):
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set the max-age for a bridge.
Use the no parameter with this command to restore the default value of max-age.
3. Command Syntax:
bridge GROUP max-age MAXAGE
no bridge GROUP max-age
GROUP <1-1> The ID of the bridge group to which this maximum age time is assigned.
MAXAGE <6-28> The maximum time, in seconds, to listen for the root bridge.
4. Example:
The following example sets the max-age MAXAGE (28) of bridge GROUP (1):
switch_a(config)#bridge 1 max-age 28
switch_a(config)#
Forward Delay (sec) (4..30):
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set the time (in seconds) after which (if this bridge is the root bridge)
each port changes states to learning and forwarding.
Use the no parameter with this command to restore the default value.
3. Command Syntax:
bridge GROUP forward-time FORWARD_DELAY
no bridge GROUP forward-time