LevelOne IES-1081 User Manual
Page 139
IES-1081 User Manual
Page 139
Use this command to specify the IP address or Domain name of NTP server.
3. Command Syntax:
ntp server IP-ADDRESS｜DOMAIN-NAME
IP-ADDRESS A.B.C.D specifies the IP address of NTP server.
DOMAIN-NAME Specifies the Domain name of NTP server.
4. Example:
The following example specifies the IP address (192.168.1.100) of NTP server:
switch_a(config)#ntp server 192.168.1.100
switch_a(config)#
Sync Time:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use ntp sync-time command to synchronize time with NTP server.
3. Command Syntax:
ntp sync-time
4. Example:
The following example synchronizes time with NTP server:
switch_a(config)#ntp sync-time
switch_a(config)#
Time Zone:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to to set time zone.
3. Command Syntax:
clock timezone TIMEZONE
TIMEZONE Specifies the time zone. (Please refer the Appendix B)
4. Example: