LevelOne IES-1081 User Manual
Page 133
IES-1081 User Manual
Page 133
The following example sets GVRP applicant state to active on the interface fe1 (port 1):
switch_a(config)#set gvrp applicant state active fe1
switch_a(config)#
Per port setting:
GVRP registration:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set GVRP registration to normal, fixed, and forbidden registration
mode for a given port.
3. Command Syntax:
set gvrp registration normal IF_NAME
set gvrp registration fixed IF_NAME
set gvrp registration forbidden IF_NAME
normal Specify dynamic GVRP multicast registration and deregistration on the port.
fixed Specify the multicast groups currently registered on the switch are applied to the
port, but any subsequent registrations or deregistrations do not affect the port. Any
registered multicast groups on the port are not deregistered based on the GARP timers.
forbidden Specify that all GVRP multicasts are deregistered, and prevent any further
GVRP multicast registration on the port.
IF_NAME The name of the interface.
4. Example:
The following example sets GVRP registration to fixed registration mode on the interface
fe1 (port 1):
switch_a(config)#set gvrp registration fixed fe1
switch_a(config)#
IGMP Snooping
IGMP mode:
Querier:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use ip igmp snooping querier command to enable IGMP querier operation on a subnet