LevelOne IES-1081 User Manual
Page 87
IES-1081 User Manual
Page 87
switch_a(config)#interface fe1
switch_a(config-if )#shutdown
switch_a(config-if )#
Duplex:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if )#
2. Usage:
Use duplex command to specify the duplex mode to be used for each interface.
Use the no duplex to disable this function.
3. Command Syntax:
(no) duplex MODE
MODE specifies the duplex mode: auto, full, half.
4. Example:
The following example shows the use of duplex MODE (full) to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if )#duplex full
switch_a(config-if )#
Flow control:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if )#
2. Usage:
Use flowcontrol on command to enable flow control, and configure the flow control
mode for the port.
Use the no flowcontrol to disable this function.
3. Command Syntax:
flowcontrol on