Teledyne LeCroy USBTracer_Trainer - Users Manual - Manual (Page 329)

USB Protocol Suite User Manual Chapter 12: Traffic Generation (3.0 Exerciser)
LeCroy Corporation
315
12.6.12 Text Snippets
Text snippets appear in the Text Snippets window. You can drag and drop a text snippet
into the script. The available text snippets are:
• Send: Enter a packet template name, with options to delay or override.
• SendPipeCommand: Enter a command name, pipe type, total length, setup,
data pattern, asn, store data, and send erdy.
• SetSequenceNumber: Enter a pipe type, device address, endpoint number,
data directory, sequence number, and enable.
• SendFile: Enter a file path, device address, endpoint, delay,
start sequence number, payload_size, stream ID, and route string.
• PrepareWaitPkt: Enter packet type as TP or DP, requested packet subtype for TP,
packet endpoint number, packet device address, packet direction, and
packet stream ID.
• WaitPacket: Enter packets to wait (default is 1) and start wait at last end
(default is 1) or not (0).
• TxSleep: Enter an interval.
• Set Link State: Enter a link state.
• Loop: Enter a counter.
• Start Recording: Enter the Recorded Options File Path and Name and the Trace
File Path and Name. Indicate whether to keep the old trace.
• Stop Recording: Enter 0 (no WaitForUpload) or 1 (WaitForUpload). You can also
force to stop recording.
• Trigger Analyzer: Has no options.
• for: Enter code between the braces.
• Call: Enter a Procedure name and the procedure parameters.
• Packet Size: Enter an integer or a template.
• Pattern Size: Enter an integer or a data pattern.
• Field Size: Enter an integer or a field name.
• Set: After the set command, enter a setting and its value.
• Trace_B: Enter a message.
• Trace: Enter a message.
• DeviceEnumerationInit.snpt: Text snippet for device enumeration.