Teledyne LeCroy UWBTracer User Manual - Manual (Page 107)

UWBTracer/Trainer User Manual Chapter 7: Decoding USB/WUSB Requests
LeCroy Corporation
89
The Class/Vendor Endpoint Decoding options an IN or Interrupt endpoint are:
• No Decoding
• CCID Bulk In Message
• Communication Class Interrupt Notification
• Display DATA
• HID In Endp
• Hub Class Status Change Endp
• Mass Strg Bulk-Only SCSI In Endp
• Mass Strg CBI Interrupt Endp
• Mass Strg UFI_CBI Bulk In Endp
• Mass Strg UFI_CBI Interrupt Endp
• Still Image/PTP/MTP/PictBridge Bulk In
• Still Image/PTP/MTP/PictBridge Interrupt
• Video Bulk In
• Video Interrupt
• Video Isoch In
• Virtual UART
• Wire Adapter Radio Notif Endp
• Wire Adapter Data Transfer In Endp
• Wire Adapter Notif Endp
Step 6 Select the type of decoding.
OR
Select No Decoding if you do not want any specific decoding.
Step 7 Repeat the previous steps for any additional endpoints you would like to
map.
Step 8 To retain a mapping from trace to trace DURING an application session,
select the Keep Across Recordings checkbox.
Step 9 Click OK.