Teledyne LeCroy UWBTracer User Manual - Manual (Page 138)

Chapter 9: Reports UWBTracer/Trainer User Manual
120
LeCroy Corporation
Graph Properties for Frame Occurrences
Figure 9.20 shows the Graph Properties dialog box for the Frame Occurrences graph, at
the Data Frames panel. You can select from graphs that show statistics about different
frame types: Beacons, Control Frames, Command Frames, Data Frames, Aggregated
Data Frames, and Device-specific and General Events.You can change the Appearance
and Color. Graphs for each analyzer in the analyzer network (SN566, SN567 and so on)
are listed separately. When you add a new analyzer to the analyzer network, a new set
of graphs is added to the list.
Figure 9.20 Graph Area Properties for Data Frames
Buttons
By default, all checkboxes are selected.
To remove a frame type from the display, deselect the frame type checkbox.
To add a frame type for a device, click New and select the device and frame type.
To delete a frame type for a device, highlight the frame type, then click Delete.
To restore the default settings for all frames, click Restore defaults.