Teledyne LeCroy UWBTracer User Manual - Manual (Page 178)

Chapter 10: Connecting to Analyzers UWBTracer/Trainer User Manual
160
LeCroy Corporation
Remote Analyzers Over an IP Network Configuration
To configure UWBTracer/Trainer to remotely control an analyzer over an IP LAN, you use
the Analyzer Network dialog to browse to the host controlling the analyzer and add both
the host and its PC to the dialog.
Step 1 From the menu, select Setup > Analyzer Network to open the
Analyzer Network dialog box and list host PCs and their analyzers. The
listed devices are either currently connected or were connected before.
Figure 10.5 Analyzer Network Dialog Box
Step 2 Remove any host (other than the Local Machine) from the list by
selecting the host and then clicking Remove. You should keep in the list
only the host(s) that you are planning to immediately use.