Vanguard CT-8000 S3 - Manual (Page 73)

REV 1 CT-8000 S3 USER’S MANUAL
68
3.3.5. Performing a Static Resistance Test
The CT-8000 S3 can also be used as a 200 Ampere micro-ohmmeter. Follow the steps below to
perform a static resistance test:
a. Start from the "START-UP" Menu:
Press the
[1]
key (RUN TEST).
b. The following screen will be displayed:
'
Press the [3] key (STATIC RES TEST).
c. The following screen will be displayed:
Press the [ENTER] key.
d. The following screen will be displayed momentarily:
CABLES ENERGIZED!
STATIC RES TEST
CONNECT DCR CABLES
THEN
"ENTER" TO BEGIN
1. TIME DRY CONTACTS
2. TIME LIVE CONTACTS
3. STATIC RES TEST
4. DYNAMIC RES TEST
1. RUN TEST 10/08/13
2. GET RESULTS 10:10:10
3. SAVE/RESTORE
4. SETUP
5. DIAGNOSTICS