Vanguard CT-8000 S3 User Manual
Page 77
REV 1 CT-8000 S3 USER’S MANUAL
72
g. The following screen will be displayed:
Continue to hold down the
[ARM]
switch until testing is finished. You will be returned
to the “START-UP” menu once testing is finished. You will be returned to the "START-
UP" menu once testing is finished.
See section 3.3.7 for instructions on how to print the test results and graph. Dynamic
Resistance Graphs are shown in Figure 24, Figure 25, and Figure 26.
NOTE
When printing the dynamic test results, the timing graph will also be printed
after the dynamic resistance graph.
Figure 24. Dynamic Resistance Graph (0 - 400 micro-ohm linear scale)
TEST IN PROGRESS
HOLD "ARM" UNTIL
TEST COMPLETES.
(UP TO 25 SECONDS)
Travel transducer trace
Contact resistance trace