WolfVision EYE-14 User Manual - Manual (Page 10)

Please note that the EYE-14 has an optical 14x zoom. The digital 4x zoom increases the overall zoom
range to a 56x zoom. The pick-up sizes are dependent on distance between camera and object.
When you zoom in, the zoom will be stopped at optical end position, when you zoom in further the digital
zoom is automatically activated to extend the optical tele.
However please be aware that when the digital zoom is used, the resolution of the picture is not as good as
before.
The behavior of the EYE-14 in the digital zoom mode can be changed in the on-screen menu (see page 15).
Optical Zoom / Digital Zoom
When the unit is turned on the focus automatically adjusts to the object.
Please note that objects with very low contrast (like a blank sheets of paper) are difficult to focus.
For special applications the autofocus can also be switched off using the on/off switch (#30). The autofocus
is also switched off when the manual FOCUS keys (#31) are used.
Focusing / Autofocus
The unit offers the possibility to store the current settings as a Preset and recall them by just pressing the
respective PRESET key (#27) on the remote control.
For storing a reset adjust y function as required and then PRESET key
for 2 seconds . An on-screen message inform you when the Preset is stored.
As mentioned above, when presets are stored all current settings such as zoom, focus, iris etc. are also
stored. Contrary to this, a user also has the opportunity to assign specific functions such as "NEGATIVE",
"NEGATIVE/BLUE", "BLACK/WHITE", "FREEZE", "LASER" etc. to a PRESET key in the on-screen menu
of the EYE-14 (see page 15).
p : an press any one of the s on the
remote control or more will
Preset Function
9
The current image can be captured by pressing the FREEZE key (#39).
This can be used to prepare the next object while the audience is watching the frozen image.
Freeze
EYE-14 is equipped with an auto exposure to control gain, shutter and mechanical iris. This means that the
brightness of the camera image adjusts automatically.
Using the EXPOSURE keys (#19) manually darkens or brightens the image.
The standard auto exposure level (Image Brightness) can also be set brighter or darker in the unit's on-
screen menu.
When picking up areas with bright spots, Back Light Compensation can be switched on in the unit‘s on-
screen menu.
When changing Shutter to OFF or 1/30, the Center Lasermarker will be switched off to prevent visibility in
the picture. For temporarily switching the laser on in such situation, assign the LASER function to a preset
key - see below.
Automatic / Manual Exposure
The info screen will be displayed by pressing the ? HELP key (#20) on the remote control.
Information like currently available recording time, recording state and audio settings will be displayed.
The info screen will be hidden after a few seconds automatically.
Info Screen (status)
At the left lower corner, respective icons will inform you about active streaming, recording and mic status.
Status Icons