WolfVision EYE-14 User Manual - Manual (Page 27)

#31
#33
#39
#28
#27
#19
#34
#30
#29
#22
#37
#38
#32
#26
#36
#35
#25
#23
#20
#21
#24
#40
#43
#42
#44
#41
Storing presets:
Press the desired PRESET key (#27) for 2 seconds.
Recalling presets:
Press the desired PRESET key (#27) quickly.
Activating the on-screen menu:
Press the MENU key (#43) to activate the on-screen
menu. Use the Navigation keys (#21 and #42) to
navigate and OK key (#22) to select. For the help
function, press the ? HELP key (#20).
For resetting only the selected item press the ? HELP
key (#20)
Activating the on-screen Extra menu:
Press the MENU key (#43) and keep it pressed until
the extra menu appears
Resetting the output mode to the default of "XGA
at 60Hz":
Keeping the POWER key (#44)pressed for more than
4 seconds.
Change IR code:
Change the IR code in the
"Advanced
Settings / Miscelaneous Settings" and set the "IR
Code" to A, B, C or D (code A is default). To change the
IR code on the remote control, simultaneously
press ress PRESET 1, PRESET 2 keys
and the
ZOOM TELE key
ress PRESET 1, PRESET 2 and
ZOOM WIDE
.
.
on-screen menu
p (#27)
(#34). Each time this key
combination is used, the code switches from A to B, C,
D ... A ... in the order given.
For resetting the remote control to code A,
simultaneously p
.
The LED on the remote control shows the selected
code (it flashes one time for code A, two times for code
B, three times for code C and four times for code D).
Resetting the output mode to the default of "XGA
at 60Hz":
Keeping the POWER key (#4)pressed for more than 4
seconds
.
CODES - Short Keys
Camera
IR-Remote Control
#4
26