WolfVision EYE-14 User Manual - Manual (Page 2)

Precautions
ENGLISH
Please observe the following:
Risk of electric shock
Dangerous voltage inside
WARNING!
CAUTION! INSTALLATION AND SERVICING OF THE UNIT MUST BE PERFORMED BY QUALIFIED
SERVICE/INSTALLATION PERSONNEL FOLLOWING THE MANUFACTURER'S INSTALLATION
INSTRUCTIONS AND IN COMPLIANCE WITH THE NATIONAL ELECTRIC CODE, ALL LOCAL
BUILDING AND SAFETY CODES AND ALL OTHER APPLICABLE CODE PROVISIONS OR
REGULATIONS.
USE THIS UNIT ONLY WITH THE CORRECT VOLTAGE AS SHOWN ON THE TYPE LABEL !
DO NOT EXPOSE THE UNIT TO HEAT OR MOISTURE !
PROTECT THE UNIT FROM EXCESSIVE SHOCKS !
USE SECURITY ROPE TO PREVENT IT FROM FALLING DOWN !
Make sure that sufficient air circulation for cooling the unit is possible!
If there is any abnormality (abnormal noise, smell, smoke etc.) disconnect the unit from mains
immediately and contact your WolfVision partner!
Do not use a damaged power cord. This may cause short circuits or electrical shocks!
To prevent danger, do not modify the unit or operate without the cover panel firmly in place!
Do not expose the unit to water, metallic objects or any flammable material.
Avoid installing the unit in locations exposed to strong magnetic fields or electrical currents.
Avoid installing the unit in environments where there is radiation. This could cause monitor image
distortion or damage to the camera sensor.
Do not pull the plug from the power socket with wet hands!
If the unit is not used for a long time, disconnect it from mains!
Use supplied power supply, it is approoved in accordance to CSA 22.2-60950 or UL 1950.
1
Precautions for the laser pointer and laser center marker:
Laser light - Do not stare into beam!
Do not modify the laser! Do not view the laser beam with optical instruments!
Information for laser pointer
FDA accession number: 9912688-00
This device complies with 21 CFR 1040.10 and 1040.11
Technical data:
λ = 635 - 680nm
P < 1mW
Θ 2mrad
This label will be found on the
underneath of the remote
control.
Information for the Center Lasermarker
The beam of the Center
Lasermarker exits the unit
beside the camera lens.
(arrow indicates the laser
beam)
Technical data:
λ = 635nm - 680nm
P < 1mW
cw/cp = 2 - 28ms
This label will be found on the
camera
.
レーザー光をのぞき込まないこと
レーザー光を人に向けないこと
本製品を子供に使わせないこと
株式会社ヴォルフビジョン
The laser beam exits the
remote control through the
smaller (left) opening on the
front.