WolfVision EYE-14 User Manual - Manual (Page 16)

15
For regular use of the WolfVision EYE-14, it is not necessary to go into the unit's menu and change settings.
Inexperienced users should not make any adjustments here.
To enter the on-screen menu press the MENU key (#43). Settings of the unit's basic functions and the built-
in camera can be made here using the 4 SELECT keys on the remote control (#22 and #43) and the OK key
(#23).
If more information on a function in the on-screen menu is required, set the cursor in the respective line and
press the ? HELP key (#20) to display a detailed description of this function on the screen. To exit the help
function, press the ? key again.
By pressing the MENU key for 4 seconds the Extra Menu appears. In the Extra Menu, e.g. the Factory
Reset can be performed to reset all settings including resolution and IP addresses to the default.
The functions of the on-screen menu are not described in detail in this user manual as the help menu is an
integrated part of the unit's software (firmware). The information you see on your screen always belongs to
the current EYE-14 firmware.
The following chapter is for experienced users only:
ON-SCREEN MENU / ON-SCREEN HELP
Exposure Settings
Color Settings
Output Settings
Preset Control
Advanced Settings
The exposure settings will affect the brightness of the image, e.g. Gain, Shutter, Aperture, Image
Brightness and Back Light Compensation.
The Color Settings will affect the color reproduction of the camera, e.g. White Balance settings, Color Mode
and Positive/Negative.
Hint:
If the picture on your screen appears to be too light or too dark or the color saturation is not correct, the Color
Mode can be changed.
For better readability of handwritten texts, the image can be changed to BLUE.
To change the Detail Settings (sharpness) and to change the Output Resolution manually.
Hint:
Use the "Resolution Test" function to change to the selected resolution temporarily for ten seconds. This
way the compatibility of the connected display device can be easily checked.
In the "Preset Control" the Preset keys can be assigned specific functions such as "NEGATIVE/BLUE",
BLACK/WHITE", "LIGHT", etc.. Additionally the default presets can be recalled.
In this sub-menu the behavior when powering on, digital zoom, on-screen menu can be changed.
Settings for Ethernet (LAN), Date/Time, Laser and USB stick will also be found in this menu.
Hint:
Change Power-Down Mode to "ECO" or "DEEP" to save power consumption in standby mode.
Open "Device Info" to view details of the unit like currently installed firmware version.
Recall Default Menu Settings
All picture affecting settings can be set back to the factory defaults. All settings which affect the
communication with other equipment, e.g. network settings and resolution will not be changed.
Hint:
To reset single items, just select the desired line and keep ? HELP key (#20) pressed for 2 seconds.
Start Quick Setup Guide
The Quick Setup Guide will be started automatically when the EYE-14 is switched on the the first time and
can be started with this item manually. This menu will guide you through basic settings like language,
network settings, time/date and audio settings.