WolfVision EYE-14 User Manual - Manual (Page 23)

IMPORTANT:
Please give special attention to the specific country regulations for training and
conferencing rooms. G
For security reasons we are unable to provide fastening equipment for the ceiling mount with
the camera. We request that you acquire the appropriate fastening material for your particular
ceiling construction at your local hardware store. WolfVision will not take liability if substandard
material is used or the installation is done incorrectly and not according to our instructions.
Failure to follow instructions can lead to severe injury!
To avoid possible injury, ensure that the ceiling construction is able to support five
times the required camera weight!
With the 1/4” UNC thread, the EYE-14 can be mounted onto a tripod.
The UNC-threads can be found on the top and bottom sides.
On the front, a filter/adapter lens can be attached: the M42x0.75.
This could be helpful e.g. when the picked-up object would be very close to the lens, a close-up lens can be
attached.
When the EYE-14 is mounted into a housing (or ceiling) make sure to reserve space for the connected
cables (about 50 to 100 mm, depending on the cable used).
To mount the EYE-14 into suspended ceilings, use the optional available tile bridge.
INSTALLATION
IMPORTANT
Sufficient ventilation is to be provided, otherwise it can result in damage to the
equipment.
G
22
The camera is easily mounted to the ceiling with the supplied U-shaped mounting clip.
In very high rooms, the pick-up size will be too large when mounting the EYE-14 on the
ceiling.
In this case, it is recommended to use an additional ceiling hanger and the supplied
u-shaped mounting clip to suspend the EYE-14 further down from the ceiling.
Ceiling Hanger U-Shaped Mounting Clip (Ceiling Mount)
90°
9
91
R
12
25
6.5
200.5
174