IEI Integration KINO-QM57A - Manual (Page 68)

KINO-QM57A Mini-ITX SBC
Page 54
Before the KINO-QM57A is installed in the system, the jumpers must be set in accordance
with the desired configuration. The jumpers on the KINO-QM57A are listed in
6
Table 4-1.
Description Type Label
AT Power Mode Setting 3-pin header J_ATXCTL1
Clear CMOS 3-pin header J_CMOS1
COM4 Function Select 8-pin header JP2
LVDS Panel Resolution 8-pin header J_PID1
LVDS Voltage Select 3-pin header J_VLVDS1
ME RTC Register 3-pin header J_ME_RTC1
SPI ROM Program Select 3-pin header J_SPI
iTPM Enable (Reserved) 3-pin header J_ITPM1
Table 4-1: Jumpers
4.5.1 AT Power Select Jumper Settings
Jumper Label: J_ATXCTL1
Jumper Type: 3-pin header (1x3)
Jumper Settings: See Table 4-2
Jumper Location: See Figure 4-6
The AT Power Select jumper specifies the systems power mode as AT or ATX. AT Power
Select jumper settings are shown in Table 4-2.
AT Power Select Description
Short 1 - 2 Use ATX power Default
Short 2 – 3 Use AT power
Table 4-2: AT Power Select Jumper Settings