IEI Integration KINO-QM57A - Manual (Page 69)

KINO-QM57A Mini-ITX SBC
Page 55
The location of the AT Power Select jumper is shown in Figure 4-6 below.
Figure 4-6: AT Power Select Jumper Location
4.5.2 Clear CMOS Jumper
Jumper Label: J_CMOS1
Jumper Type: 3-pin header (1x3)
Jumper Settings: See
6
Table 4-3
Jumper Location: See
6
Figure 4-7
If the KINO-QM57A fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1
and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
ƒ Enter the correct CMOS setting
ƒ Load Optimal Defaults
ƒ Load Failsafe Defaults.