IEI Integration KINO-QM670 v2.01 - Manual (Page 89)

KINO-QM670 Mini-ITX SBC
Page 74
5.1 Introduction
The BIOS is programmed onto the BIOS chip. The BIOS setup program allows changes to
certain system settings. This chapter outlines the options that can be changed.
NOTE:
Some of the BIOS options may vary throughout the life cycle of the
product and are subject to change without prior notice.
5.1.1 Starting Setup
The UEFI BIOS is activated when the computer is turned on. The setup program can be
activated in one of two ways.
1. Press the F2 key as soon as the system is turned on or
2. Press the F2 key when the “Press F2 to enter SETUP” message appears on
the screen. 0.
If the message disappears before the F2 key is pressed, restart the computer and try
again.
5.1.2 Using Setup
Use the arrow keys to highlight items, press E NTER to select, use the PageUp and
PageDown keys to change entries, press F1 for help and press E SC to quit. Navigation
keys are shown in the following table.
Key Function
Up arrow Move to the item above
Down arrow Move to item below
Left arrow Move to the item on the left hand side
Right arrow Move to the item on the right hand side
+ Increase the numeric value or make changes