IEI Integration IMBA-9454 v1.00 - Manual (Page 109)

IMBA-9454 Motherboard
Page 91
Figure 5-9: Jumper Locations
5.4.1 CF Master/Slave Selection
Jumper Label: JP2
Jumper Type: 2-pin header
Jumper Settings: See Table 5-2
Jumper Location: See Figure 5-9
The CF Master/Slave Selection jumper sets the CF Type I card or CF Type II cards as
either the slave device or the master device. CF Master/Slave Selection jumper settings
are shown in Table 5-2.
Pins Description
Open Slave Default
Short Master
Table 5-2: CF Master/Slave Selection Settings