IEI Integration IMBA-9454 v1.00 - Manual (Page 142)

IMBA-9454 Motherboard
Page 124
ECP The parallel port operates in the extended
capabilities port (ECP) mode. The ECP mode
supports bi-directional communication between the
system and the parallel port device and the
transmission rates between the two are much faster
than the Normal mode
ECP+EPP The parallel port is also compatible with both ECP
and EPP devices described above
Parallel Port IRQ [IRQ7]
Use the Parallel Port IRQ option to set the parallel port interrupt address.
IRQ5 IRQ5 is assigned as the parallel port interrupt address
IRQ7 D EFAULT IRQ7 is assigned as the parallel port interrupt address
Onboard CIR Port [Disabled]
Use the Onboard CIR Port option to select the CIR base address.
Disabled D EFAULT No base address is assigned to CIR
3E0 CIR base address is 3E0
2E0 CIR base address is 2E0
Serial Port3 Address [3E8]
Use the Serial Port3 Address option to select the base addresses for serial port 3
Disabled No base address is assigned to serial port 3
3E8 D EFAULT Serial port 3 I/O port address is 3E8