IEI Integration IMBA-G410 v1.01 - Manual (Page 95)

2011/8/172011/8/17
IMBA-G410 ATX Motherboard
Page 81
Normal D EFAULT The normal parallel port mode is the standard mode
for parallel port operation.
Bi-directional Parallel port outputs are 8-bits long. Inputs are
accomplished by reading 4 of the 8 bits on the
status register.
EPP The parallel port operates in the enhanced parallel
port mode (EPP). The EPP mode supports
bi-directional communication between the system
and the parallel port device and the transmission
rates between the two are much faster than the
Normal mode.
ECP+EPP The parallel port operates in the extended
capabilities port (ECP) mode. The ECP mode
supports bi-directional communication between the
system and the parallel port device and the
transmission rates between the two are much faster
than the Normal mode
The parallel port is also be compatible with EPP
devices described above
Parallel Port IRQ [IRQ7]
Use the Parallel Port IRQ selection to set the parallel port interrupt address.
IRQ5 IRQ5 is assigned as the parallel port interrupt address
IRQ7 D EFAULT IRQ7 is assigned as the parallel port interrupt address
5.4.3 Console Redirection Configuration
Use the Console Redirection Configuration menu (
67
BIOS Menu 7) to configure the
console redirection configuration options for remote access.