IEI Integration TANK-700-QM67 v1.00 - Manual (Page 29)

TANK-700 Embedded System
Page 18
Figure 3-3: HDD Installation
Step 5: Slide the HDD bracket to connect the HDD to the SATA connector. Secure the
HDD bracket with TANK-700 by the 2 retention screws that were previously
removed (Figure 3-4).
Figure 3-4: HDD Bracket Installation
Step 6: Reinstall the bottom panel to the TANK-700.
3.3 Pluggable CAN-bus Terminal Block Installation
To install the pluggable CAN-bus terminal block, please follow the steps below:
Step 1: Locate the CAN-bus terminal block connector. The location of the connector is
shown in Figure 1-2.