Luggable, Emote, Ontrol – IEI Integration TANK-700-QM67 v1.00 User Manual
Page 31: Erminal, Lock, Nstallation
TANK-700 Embedded System
Page 20
Figure 3-6: Pluggable DC-in Terminal Block Installation
3.5 Pluggable Remote Control Terminal Block Installation
To install the pluggable remote control terminal block, please follow the steps below:
Step 1:
Locate the remote control terminal block connector. The location of the
connector is shown in Figure 1-3.
Step 2:
Align the pluggable remote control terminal block with the remote control
terminal block connector on the TANK-700.
Step 3:
Once aligned, insert the pluggable remote control terminal block into the remote
control terminal block connector.
Step 4:
Secure the pluggable remote control terminal block to the external interface by
tightening the two retention screws on either side of the terminal block
(Figure 3-7).