IEI Integration PPC-37xx-N270 v2.00 - Manual (Page 49)

PPC-37xx-N270 Panel PC
Page 35
Step 5: Connect the SATA cable from the motherboard to the rear of the HDD. Step 0:
4.8.2 PPC-3710 HDD Installation
To install the HDD into the PPC-3710, please follow the steps below:
Step 1: Remove the back cover. See Section 4.5.2 above.
Step 2: Remove the HDD bracket from the PPC-3710. The HDD bracket is attached on
the PPC-3710 with four retention screws inside the chassis (Figure 4-8).
Remove the four retention screws and lift the bracket off the panel PC.
Figure 4-8: PPC-3710 HDD Bracket Retention Screws
Step 3: Attach the HDD bracket to the HDD. To do this, align the four retention screw
holes in the HDD bracket with the retention screw holes on the bottom of the
HDD. Insert four retention screws into the HDD bracket. (Figure 4-9).