IEI Integration PPC-37xx-N270 v2.00 - Manual (Page 50)

PPC-37xx-N270 Panel PC
Page 36
Figure 4-9: PPC-3710 HDD Retention Screws
Step 4: Install the HDD into the PPC-3710 by aligning the retention screw holes in the
HDD bracket with the retention screw holes on the panel PC. Insert the four
retention screws.
Step 5: Connect the SATA cable from the motherboard to the rear of HDD. Step 0:
4.8.3 PPC-3712 HDD Installation
To install the HDD, please follow the steps below:
Step 1: Remove the back cover. See Section 4.5.3 above.
Step 2: Remove the CD-ROM bracket. See Section 4.9 Step 3 below.
Step 3: Attach the HDD brackets to the HDD. To do this, align the two retention screw
holes in each HDD bracket with the retention screw holes on the side of the
HDD. Insert two retention screws into both brackets on both sides of the HDD
(Figure 4-10).