IEI Integration ACT-457A - Manual (Page 23)

ACT-457A Panel PC
Page 15
2.3 Installation and Configuration Steps
The following installation steps must be followed.
Step 1: Unpack the ACT-457A
Step 2: Install SD card (if not pre-installed)
Step 3: Configure the system
Step 4: Connect peripheral devices to the bottom panel of the ACT-457A.
Step 5: Mount the ACT-457A S te p 0 :
2.4 Rear Panel Removal
To access the jumpers and connectors, the rear panel must be removed.
Step 1: Place the ACT-457A monitor side down on a flat surface.
Step 2: Remove the rear panel screws and lift the back cover off. S te p 0 :
Figure 2-1: Rear Panel Retention Screws