Figure 3-5: set mifare parameter, Table 3-7: set mifare parameter raw data format, Ed in table 3-3 and table 3-4 – IEI Integration ACT-457A User Manual
Page 45
Advertising
ACT-457A Panel PC
Page 37
Step 2:
Select a Mifare mode.
0-UUID: read serial number only.
1-UUID & KEY A: read serial number and use "KEY A" to read "Block' data".
2-UUID & KEY B: read serial number and use "KEY B" to read "Block data".
Step 3:
Configure the block number, and key data (Figure 3-5).
Step 4:
Click the Execute button to execute the command through the selected serial
port (Figure 3-5). The raw data of this command shows in the Raw Data area in
the format listed in Table 3-7 and Table 3-8.
Step 0:
Figure 3-5: Set Mifare Parameter
Field
Command
Access Mode
Block
KEY Data
End
Digit 2
1
2
12
1
Data SM
0~2
00~63
000000000000
︴(Hex)
FFFFFFFFFFFF
CR (0x0d)
Table 3-7: Set Mifare Parameter Raw Data Format
Advertising