IEI Integration ACT-457A - Manual (Page 32)

ACT-457A Panel PC
Page 24
NOTE:
When purchasing the arm please ensure it has a 75 mm x 75 mm
mounting hole pattern. Only this mounting size will support the
ACT-457A.
Step 2: Once the mounting arm has been firmly attached to the surface, lift the flat panel
PC onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the
flat panel PC. The ACT-457A arm mount retention screw holes are shown in
Figure 2-13.
Figure 2-13: ACT-457A Arm Mounting Retention Screw Holes
Step 4: Secure the flat panel PC to the interface pad by inserting four retention screws
through the bottom of the mounting arm interface pad and into the flat panel