2 write block, Table 3-3: read block raw data format, Table 3-4: read block response format – IEI Integration ACT-457A User Manual
Page 43
ACT-457A Panel PC
Page 35
Field
Command Block
KEY
KEY Data
Time Out
End
Data RB
00~63
A/B 000000000000
︴(Hex)
FFFFFFFFFFFF
00~99
(Second)
CR
(0x0d)
Table 3-3: Read Block Raw Data Format
Status (2 digits)
Block Data (32 digits)
END (2 digits)
OK
32 bits (Hex)
CR,LF (0x0d,0x0a)
ER
Error Code (3 digits)
CR,LF (0x0d,0x0a)
Table 3-4: Read Block Response Format
3.5.2 Write Block
To write the block data into a Mifare card, please follow the steps below.
Step 1:
Select Write Block in the command area (Figure 3-4).
Step 2:
Configure the data, including block, key, key data, time out and data
(Figure 3-4).
Step 3:
Click the Execute button to execute the command through the selected serial
port (Figure 3-4). The raw data of this command shows in the Raw Data area in
the format listed in Table 3-5 and Table 3-6.
Step 0: