IEI Integration AFL2-12A-D525 - Manual (Page 49)

AFL2-12A-D525 Series Panel PC
Page 49
4.9 Mounting the System
WARNING!
When mounting the flat bezel panel PC onto an arm, onto the wall or onto a
panel, it is better to have more than one person to help with the installation
to make sure the panel PC does not fall down and get damaged.
The four methods of mounting the AFL2-12A-D525 are listed below.
ƒ Wall mounting
ƒ Stand mounting
ƒ Arm mounting
ƒ Rack mounting
The four mounting methods are described below.
4.9.1 Wall Mounting
To mount the flat bezel panel PC onto the wall, please follow the steps below.
Step 1: Select the location on the wall for the wall-mounting bracket.
Step 2: Carefully mark the locations of the four screw holes in the bracket on the wall.
Step 3: Drill four pilot holes at the marked locations on the wall for the bracket retention
screws.
Step 4: Align the wall-mounting bracket screw holes with the pilot holes.
Step 5: Secure the mounting-bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them (Figure 4-10).