2 wlan card replacement, Figure 5-3: ddr so-dimm module installation – IEI Integration AFL2-12A-D525 User Manual

Page 69

Advertising

AFL2-12A-D525 Series Panel PC

Page 69

Step 8:

Install the new DDR3 memory module by pushing it into the socket at an angle

Step 9:

Gently pull the spring retainer clips of the SO-DIMM socket out and push the

rear of the DDR memory module down (Figure 5-3).

Step 10:

Release the spring retainer clips on the SO-DIMM socket. They clip into place

and secure the DDR memory module in the socket.

Figure 5-3: DDR SO-DIMM Module Installation

Step 11:

Replace the internal aluminum cover and secure it to the chassis using six (6)

retention screws.

Step 12:

Replace the back cover and secure it using nine (9) previously removed

retention screws.

Step 0:

5.5.2 WLAN Card Replacement

The AFL2-12A-D525 has one WLAN card slot. To replace the WLAN card, follow the

instructions below.

Step 1:

Follow all anti-static procedures. See Section 5.2.

Step 2:

Turn off the power. See Section 5.3.

Step 3:

Remove the back cover. See Section 5.4.1.

Step 4:

Remove the internal aluminum back cover. See Section 5.4.2.

Advertising