Zanussi FE 1014 N - Manual (Page 12)

Example:
In this case, the spin
(at the speed provided
for the selected type of
fabric) will be
performed.
This button allows you also to select special
programmes, such as RINSES, SPIN and DRAIN.
• If the machine is already switched on because it
has just performed a washing programme, proceed
as follows:
- depress RESET once or repeatidly to cancel the
previously performed programme (all the phase
indicator lights must be off);
- select the type of fabric by means of the relevant
button;
- select the special programme:
• RINSES AND SPIN
Depress RESET once, the pilot light (WASH)
goes out.
• SPIN
Depress RESET twice, the pilot lights WASH
and RINSES
go out.
• DRAIN
Depress RESET three times, the pilot lights
WASH
, RINSES and SPIN go out.
Example:
In this case the
machine will perform
the rinses and spin.
• If the machine is switched off:
- depress ON/OFF button to switch it on;
- select the type of fabric by means of the relevant
button:
- select the special programme as previously
described.
9 Programme phase indicator
lights
When you select a programme, the lights relevant to
the phases that form the programme light up.
After you have started the programme, only the light
relevant to the phase that is currently being carried
out will remain lit.
At the end of the programme the pilot light
illuminates.
If the light lights up at the end of the programme
this means that the drain filter is clogged.
The END pilot light flashes in the event of
operating problems.
At the same time one of the following lights starts to
flash:
= the machine does not fill
= the machine does not empty
= the door has not been closed
To eliminate the problem, see paragraph
“Something not working”.
PREWASH
WASH
RINSES
RINSE HOLD
SPIN
DRAIN
FILTER
END
12
132996790.qxd 10/12/01 12:20 PM Pagina 12 (Nero/Process Black pellicola)