Zanussi FE 1014 N - Manual (Page 22)

Something not working?
Problem Possible cause
• The machine does not start up: • The door is not firmly closed.
• The machine is not plugged in or there is no power
at the socket.
• The main fuse has blown.
• The START/PAUSE button has not been
depressed.
• The machine does not fill: • The water tap is closed.
• The inlet hose is squashed or kinked.
• The filter in the inlet hose is blocked.
• The door is not properly closed.
• The machine fills then empties
immediately:
• The end of the drain hose is too low. Refer to
relevant paragraph in “water drainage” section.
• The machine does not empty
and/or does not spin:
• The drain hose is squashed or kinked.
• The RINSE HOLD option has been selected.
• The drain filter is clogged.
• There is water on the floor: • Too much detergent or unsuitable detergent
(creates too much foam) has been used.
• Check whether there are any leaks from one of the
inlet hose fittings. It is not always easy to see this
as the water runs down the hose; check to see if it
is damp.
• The drain hose is damaged.
• Unsatisfactory washing results: • Too little detergent or unsuitable detergent has
been used.
• Stubborn stains have not been treated prior to
washing.
• The correct temperature was not selected.
• Excessive laundry load.
• The machine vibrates or is noisy: • The transit bolts and packing have not been
removed.
• The support feet have not been adjusted.
• The laundry is not evenly distributed in the drum.
• Maybe there is very little laundry in the drum.
• The door will not open: • The programme is still running, the drum is
turning.
• The door lock has not yet released.
• The water level is above the bottom edge of the door.
• The machine is heating the water.
Problems which you can resolve yourself.
During machine operation it is possible that the light , the light of the START/PAUSE button and one of
the following lights start to flash:
: problem with the water supply
: problem with water draining
: door open
Once the problem has been eliminated, press the START/PAUSE button to restart the programme. If after
all checks, the problem persists, contact your local Service Centre.
22
132996790.qxd 10/12/01 12:20 PM Pagina 22 (Nero/Process Black pellicola)