Avalon Stoves Freestanding Stove - Manual (Page 37)

Optional Equipment
(for qualified installers only)
3 7
Travis Industries 9 3 5 0 8 1 1 5 4 0 5 0 1 1 3
4 Remove the pilot orifice following the instructions below. Replace with the propane pilot orifice. The
propane conversion kit includes pilot orifice with "35" stamped on it. Replace burner pan.
Lift the pilot hood
off the pilot
assembly.
5/32" Hex
Use a hex wrench to
unscrew the orifice.
Remove the orifice and replace with the LP orifice. Screw the
orifice all the way in and replace the pilot assembly.
LP (Propane) Orifice
Orifice Identification:
NG (Natural Gas) Orifice
35
62
35
a
b
c
NOTE: when re-attaching,
this pin lines up with the
notch in the pilot hood.
5 Remove the regulator from the
front of the gas control valve.
Replace with the propane
regulator, using the new gasket
and screws included with the
regulator. NOTE: Leak test
this area after the heater is
installed, gas is connected,
and the main burner is lit.
Place the LP
label on top of the
control cover
near the gas
control valve.
d
a
b
Remove and discard the three
screws using a slotted screwdriver
of Torx T-20.
Remove and discard the
regulator, diaphram, spring
and center post.
Slotted
Screwdriver
(or T-20 Torx)
c
NOTE: Make sure the
regulator gasket is correctly
aligned before installation.
Install the LP regulator. Use
the screws included with the
LP regulator. Tighten to
approximately 25 Lbs. torque.
Slotted
Screwdriver
(or T-20 Torx)