SaltDogg TGSUV1B SUV Salt Spreader - Manual

1
TM
Installation Instructions
—continued inside
SPREADER ASSEMBLY
Check contents of box against parts list to make
sure all components are included. When ordering
replacement or spare parts refer to parts list for
part numbers.
TOOLS NEEDED FOR ASSEMBLY
• 3/8 or 1/2 drives ratchet with 3/8, 7/16, 1/2, 9/16
& 15/16 sockets.
• 7/16, 1/2, 9/16 & 15/16 wrench.
• 1/8" Allen wrench
SPINNER SHIELD AND RECEIVER MOUNT
See Fig.1
Install the 2" or 1¼" receiver mount (5 or 6) into
your truck or SUV receiver hitch. Secure receiver
mount using hitch pin (7). Attach the motor/frame
assembly (1) to the receiver mount by inserting the
5/8 bolt and nut (8, 9) in the bottom hole and the
hitch pin (7) in the top hole.
It is recommended to
mount the frame at the highest possible
position for assembly purposes. Install the spin-
ner shield (10) with 3/8-16 x 1 hex head cap screws,
flat washers and hex nuts (11, 12, and 13). Position
the shield about a 1/2" away from the spinner and
center it to the spinner. The shield position can be
changed later to alter the salt pattern if needed.
TGSUV1B
SUV Salt Spreader
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • saltdogg.com