SaltDogg SHPE6000 Series Electric Drive Poly Hopper Spreader User Manual

Installation instructions, Saltdogg

Advertising
background image

1

TM

Safety Precautions

1. Read this entire Owners Manual before operating this

spreader.
2. Read all safety decals on the spreader before operating.
3. Check to make sure all safety guards are securely

mounted into place before operating this spreader.
4. Verify that all personnel are clear of the spreader spray

area before starting or operating this spreader.
5. Do not over-load your vehicle beyond payload limits. If

there are any questions, contact the vehicle manufacturer.
6. Do not adjust, clean, lubricate or unclog material jambs

without first turning off the spreader.
7. Do not climb on or in the spreader during operation. Do not

ride on the spreader while the vehicle is in motion.
8. Make sure the spreader is securely fastened to the vehicle

in accordance with this manual.
9. Do not operate a spreader that is in need of maintenance

or repairs.
10. Batteries normally produce explosive gases which can

cause personal injury. Always disconnect the battery before
removing or replacing electrical components.
11. Do not leave unused material in hopper. Material can

freeze or solidify, causing spreader to not work properly, and/
or damage the unit. Empty and clean after each use.

9049 Tyler Blvd. • Mentor, Ohio 44060

Phone (440) 974-8888 • Fax (440) 974-0165

Toll-Free Fax 800-841-8003 • saltdogg.com

Installation Instructions

SaltDogg

®

Electric Drive Poly Hopper Spreader

6.0 cubic yards

—continued inside

Table of Contents

General Information ........................................1
Safety Precautions ...........................................1
Installation Instructions ............................. 2-4
Spreader Operation ...................................... 3-4
Spreader Maintenance ....................................4
Repair Parts & Drawings ............................ 5-8
Warranty Information ......................................8

General Information

Overall Length: 133.5 inches
Overall Width: 77 inches
Overall Height: 57 inches
Empty Weight: 1,344 lbs
Capacity Struck: 6.0 cu. yd.

Vehicle Requirements

Trucks with minimum GVWR 25,999 lbs.
150 AMP or higher alternator is recommended.

Average Material Weights

Materials to use

Weight (pounds per cubic yard)

Fine Salt-Dry

2,250

Coarse Salt-Dry

1,431

Sand Coarse-Dry

2,565

Note: To calculate the total spreader weight (including ice
control material), add the empty spreader weight plus the ice
control material and spreader accessories.

CAUTION

Do not overload vehicle beyond the vehicle’s GVWR

or GAWR. Check vehicle’s load rating certification

sticker for maximum vehicle capacity.

WARNING

Improper installation and operation could cause

personal injury, and/or property damage. Observe

the following Safety Precautions before, during and

after operating this spreader. By following these

precautions and common sense, possible injury to

persons and potential damage to this machine may

be avoided.

Advertising