SaltDogg SHPE6000 Series Electric Drive Poly Hopper Spreader - Manual (Page 4)

4
TM
End of Season Maintenance.
A. Wash spreader. Make sure no material or residue left in
and outside hopper.
B. Lubricate bearing using general automotive grease.
C. Inspect wire harness, connectors for broken insulation,
missing components. Replace if necessary.
D. Apply dielectric grease on all electrical connectors.
E. Store hopper indoors, in dry, cool place.
F. Inspect, clean and repaint frame.
G. Remove controller from truck. Store controller indoors, in
dry, cool place
D. SHPE6000 controller is equipped with electronic overload
and current spikes protection. Controller is not serviceable.
Controller has "Jam" light. If auger becomes jammed by
chunk of material or foreign debris "Jam" light will be
illuminated and controller will turn it self "OFF".
Controller can be restarted normally after jam removal.
Controller is equipped with internal vibrator circuit breaker.
Vibrator circuit breaker will trip and vibrator switch light
will turn "OFF" if vibrator becomes overloaded. To reset
vibrator circuit breaker turn vibrator switch off for 30 sec
then turn it on again.
Vibrator can operate continuously for 30 min max with 15
min brakes to avoid overheating.
E. Spreading pattern can be controlled by repositioning of
spinner shield on the shield bracket. Loose two screws and
slide shield into desired position, then tighten screws.
Maintenance Instructions
A. Wash spreader after every use. Make sure no material left
under auger and/or inside trough.
B. Inspect and retighten fasteners after every 10-15 hours of
operation.
C. Lubricate bearing every using general automotive grease
according to Fig.5
D. Inspect terminals/ connectors every time you disconnect
spreader from wire harness. Apply thin layer of dielectric
grease on terminals. If any tarnish/corrosion found, clean
terminals and apply dielectric grease.
Fig. 5
Grease Every 10 Hours
Remove Cover
Grease Bearing Every 15-20 Hours
WARNING
Never attempt to lift spreader with material in hopper!
WARNING
Never leave material in hopper for extended period
of time. Material can freeze, solidify and seriously
damage the spreader.