SaltDogg SHPE1500 Series Electric Drive Poly Hopper Spreader v.1 User Manual

Installation instructions, General information

Advertising
background image

9

TM

9049 Tyler Blvd. • Mentor, Ohio 44060

Phone (440) 974-8888 • Fax (440) 974-0165

Toll-Free Fax 800-841-8003 • saltdogg.com

Installation Instructions

—continued inside

Salt Dogg

Spreader Hopper Poly Electrical

1.5 cubic yards

Protected by U.S. patent D520 524; other patents pending

Table of Contents

General Information .................................................. ..................1
Safety Precautions ..................................................... ..................1
Warranty Information ............................................... ..................2
Installation Instructions ........................................... ..................2
Spreader Operation ......................................................................5
Spreader Maintenance ............................................. ...................5
Repair Parts & Drawings ........................................................ 6-9

Note: This manual applies to spreaders with serial numbers
2700 and above.

General Information

Spreader model no.s:
• SHPE1500 - spreader with standard chute
• SHPE1500X - spreader with extended chute
Overall Length: 92-1/8"
Overall Width: 50-1/2"
Overall Height (installed): 37-1/2"
Empty Weight: 410 lbs.
Capacity Struck: 1.5 cu. yd.

Vehicle Requirements

• 3/4 or 1 ton Pickup Truck above 8500# GVWR.

• 135 amp or higher alternator is recommended.

SHPE1500 SALT DOGG SPREADER WARRANTY

INFORMATION

This warranty replaces all previous warranties and

no employee of this company is authorized to extend

additional warranties, or agreements, or implications

not explicitly covered herein.

Buyers Products Company warrants all parts of the

product to be free from defects in material and work-

manship for a period of one (1) year. Parts must be

properly installed and used under normal conditions.

Normal wear is excluded.

Any part, which has been altered, including modifica-

tions, misuse, accident, or lack of maintenance will

not be considered under this warranty.

The sole responsibility of Buyers Products Company

under this warranty is limited to repairing or replac-

ing any part(s), which are returned, prepaid, 30

days after such defect is discovered, and returned

part(s) are found to be defective by Buyers Products

Company.

Authorization from Buyers Products Company must

be obtained before returning any part. The following

information must accompany defective parts returned

to Buyers Products Company: RMA #, spreader model,

serial number, date installed, and distributor from

whom purchased.

Buyers Products Company shall not be liable for

damage arising out of failure of any unit to operate

properly, or failure, or delay in work, or for any con-

sequential damages. No charges for transportation

or labor performed on any part will be allowed under

this warranty.

CAUTION

Do not overload vehicle beyond the vehicle’s GVWR or GAWR.
Check vehicle's load rating certification sticker for maximum
vehicle capacity.

Average Material Weights

Materials to use

Weight (pounds per cubic yard)

Fine Salt-Dry

2,250

Coarse Salt-Dry

1,431

Sand/Salt up to 50/50 Mix-Dry

2,700

Note: To calculate the total spreader weight (including ice
control material), add the empty spreader weight plus the ice
control material and spreader accessories.

Advertising