SaltDogg SHPE3000 Series Electric Drive Poly Hopper Spreader - Manual

1
TM
Safety Precautions
1. Read this entire Owners Manual before operating this
spreader.
2. Read all safety decals on the spreader before operating.
3. Check to make sure all safety guards are securely
mounted into place before operating this spreader.
4. Verify that all personnel are clear of the spreader spray
area before starting or operating this spreader.
5. Do not over-load your vehicle beyond payload limits. If
there are any questions, contact the vehicle manufacturer.
6. Do not adjust, clean, lubricate or unclog material jambs
without first turning off the spreader.
7. Do not climb on or in the spreader during operation. Do not
ride on the spreader while the vehicle is in motion.
8. Make sure the spreader is securely fastened to the vehicle
in accordance with this manual.
9. Do not operate a spreader that is in need of maintenance
or repairs.
10. Batteries normally produce explosive gases which can
cause personal injury. Always disconnect the battery before
removing or replacing electrical components.
11. Do not leave unused material in hopper. Material can
freeze or solidify, causing spreader to not work properly, and/
or damage the unit. Empty and clean after each use.
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • saltdogg.com
Installation Instructions
SaltDogg ® Electric Drive
Poly Hopper Spreader
3.0 cubic yards
starting with Serial Number 00500
—continued inside
Table of Contents
General Information ........................................1
Safety Precautions ...........................................1
Warranty Information ......................................2
Installation Instructions ............................. 2-4
Spreader Operation ..........................................5
Spreader Maintenance ....................................5
Repair Parts & Drawings ...........................6-10
General Information
Overall Length: 123.7 inches
Overall Width: 49.6 inches
Overall Height: 52.7 inches
Empty Weight: 945 lbs
Capacity Struck: 3.0 cu. yd.
Vehicle Requirements
Trucks with minimum GVWR 13,000 lbs.
150 AMP or higher alternator is recommended.
Average Material Weights
Materials to use Weight (pounds per cubic yard)
Fine Salt-Dry 2,250
Coarse Salt-Dry 1,431
Sand Coarse-Dry 2,565
Note: To calculate the total spreader weight (including ice
control material), add the empty spreader weight plus the ice
control material and spreader accessories.
CAUTION
Do not overload vehicle beyond the vehicle’s GVWR or GAWR.
Check vehicle’s load rating certification sticker for maximum
vehicle capacity.
WARNING
Improper installation and operation could cause personal
injury, and/or property damage. Observe the following Safety
Precautions before, during and after operating this spreader.
By following these precautions and common sense, possible
injury to persons and potential damage to this machine may be
avoided.
CAUTION
It is recommended to install Backup Alarm on trucks to be up
fitted with spreaders.