SaltDogg SHPE3000 Series Electric Drive Poly Hopper Spreader - Manual (Page 5)

5
TM
GREASE EVERY 10 HOURS
REMOVE COVER.
GREASE EVERY 20-25 HOURS.
Fig. 5
O. SHPE3000 is equipped with CHMSL. Route red (positive)
and white (ground) wires to connect them into vehicles stop
light connector. Extend wires as necessary. If OEM tap is not
provided, make sure to tap in after the first OEM splice from
the stop light switch in the CHMSL circuit.
Always use the tap provided by the OEM manufacturer.
DO NOT splice the white wire into the wire coming off the
stoplight switch by the brake pedal. Splicing at the stop light
switch may affect transmission shifting, cruise control, or
other vehicle functions.
(Check with the vehicle manufacturer or dealer to verify that
the CHMSL circuti is capable of powering the extra 2 AMP
load and for the location of the vehicle tap.)
3. Spreader operation.
A. SHPE3000 is equipped with a dual independent speed
controller. To start spreader, press “POWER” switch. Switch
will be illuminated. Auger and spinner will start rotating.
Auger and spinner can be adjusted independently.
B. To activate vibrator press “VIBRATOR” switch, vibrator
switch will illuminate.
C. To stop spreader press “ON-OFF” switch again.
D. SHPE3000 controller is equipped with electronic overload
and current spikes protection. Controller is not serviceable.
Controller has “Jam” light. If auger becomes jammed by
chunk of material or foreign debris “Jam” light will be
illuminated and controller will turn it self “OFF”. Controller
can be restarted normally after jam removal.
Controller is equipped with internal vibrator circuit breaker.
Vibrator circuit breaker will trip and vibrator switch light
will turn “OFF” if vibrator becomes overloaded. To reset
vibrator circuit breaker turn vibrator switch off for 30 sec
then turn it on again.
Vibrator can operate continuously for 30 min max with 15
min brakes to avoid overheating.
Controller manufacturers constantly update and modify
their product. Please check controller box for manuals and/
or updates.
E. Spreading pattern can be controlled by repositioning of
spinner shield on the shield bracket. Loose two screws and
slide shield into desired position, then tighten screws.
Spreader Maintenance.
A. Use dielectric grease on all electrical connectors.
B. Grease bearings according to FIG.5.
C. Empty spreader of all ice control materials after each use.
D. Wash spreader after each use to prevent material build up
in trough.
WARNING
Never attempt to lift spreader with material in hopper!
WARNING
Never leave material in hopper for extended period of time.
Material can freeze, solidify and seriously damage the spreader.