Watlow CAS User Manual

Page 22

Advertising
background image

12 CAS User’s Guide

Installation

1.

Place the TB-50 where you will mount it and use a pencil to trace
around the standoffs.

2.

Drill and tap #6-32 holes in the locations you marked.

3.

Place the TB-50 where you will mount it. Insert the #6 screws in the
standoffs and tighten them.

NOTE

Save the cable tie wraps, ribbon cable, and ribbon cable clamps.
You'll use them when you wire outputs to the TB-50 and when you
connect the ribbon cable.

WARNING

Do not connect power to the CAS now. Test the unit first, as
explained in the Power Wiring and System Test section.

Advertising