Save setup to job, Job select inputs – Watlow CAS User Manual
Page 54
44 CAS User’s Guide
Setup
Save Setup to Job
Use this menu to save job information for every channel, to one of eight
jobs in the CAS battery-backed RAM.
If you have not enabled the remote job control funtion, you will not be
able to save a job. If you try it, you will get this message.
Job Select Inputs
Use this menu to run up to 8 jobs remotely. It lets you set the number of
job select inputs. The CAS uses these inputs as a binary code that
specifies the job number to run. The number of inputs you choose in this
menu controls the number of jobs you can select remotely.
Below is the truth table that tells you which input states select which
jobs.
Digital Input
3
Digital Input
2
Digital Input
1
Job #
F
F
F
1
F
F
T
2
F
T
F
3
F
T
T
4
T
F
F
5
T
F
T
6
T
T
F
7
T
T
T
8
CHANNEL PROCESS UNITS
CHANNEL NAME ALARM STATUS
SAVE SETUP
TO JOB ? 1
CHANNEL PROCESS UNITS
CHANNEL NAME ALARM STATUS
CANNOT SAVE JOB
REMOTE SELECT ON
CHANNEL PROCESS UNITS
CHANNEL NAME ALARM STATUS
JOB SELECT
DIG INPUTS ? NONE