Connecting i/o to the ppc-2040, Connecting the tb50 to the ppc-2040 module, Connecting i/o to the ppc-2040 61 – Watlow PPC-2000 User Manual
Page 85: Connecting the tb50 to the ppc-2040 module 61
Advertising
PPC-2000 User’s Guide
Chapter 2: Hardware Installation
Doc.# 30002-00 Rev 2.3
Watlow Anafaze
61
Figure 2.46 Analog Output Connections on a
PPC-2030: Outputs 1 and 2 Shown
Connecting I/O to the PPC-2040
A TB50 connects to a PPC-2040 Digital I/O module through the
50 pin SCSI connector. Refer to Figure 2.47 on page 62. The
terminal block interfaces to field wiring of the digital I/O
(sensors, actuators, relays, SSRs, etc.).
Connecting the TB50 to the PPC-2040 Module
Refer to Figure 2.47 on page 62. Connect the SCSI connector
from the PPC-2040 module to the TB50.
Load
1+
1-
P PC-2030
+
-
4-20mAdc
I
Load
2+
2-
-
+
+
-
0-10Vdc
+
-
Advertising