Yokogawa 202 Field Mounting Rate Totalizer - Manual (Page 29)

7.3 REMOVING THE FRONT PANEL
The front of the instrument is removed as follows:
1. Remove both the top and bottom cover strips (ie. the dark plastic strips on
the front) by levering a screwdriver under one end.
2. Undo the seven screws retaining the front. Note that the screws should
not be removed from the front panel as they are retained by O-rings.
3. Pull the front panel free from the housing.
Replacing the front panel of the instrument is the reverse procedure. However,
ensure that the front panel is aligned at both connector points before tightening
the screws.
Installation 27