Yokogawa 414 Batch Controller - Manual (Page 13)

Operation 11
DISPLAYED INFORMATION
The display will normally show the Batch Total, which is the total count for the
current batch and is reset on each new batch.
The DISPLAY key can be used to display the following additional information:
Rate
On the first press of the DISPLAY key, the display shows RATE for one
second followed by the flowrate.
Accumulated Total
On the next press of the DISPLAY key, the display shows ACC for one
second followed by the actual total. The Accumulated Total cannot be
reset during normal operation.
LIMIT ON BATCH SIZE
To prevent accidental entry of large batch quantities, a maximum batch limit can
be programmed during calibration. The operator is then prevented from entering a
batch quantity which exceeds this value.